How to Replace one of Yours
Rear Airbags
The dynamic Bling Duo of Jon and Fast Roger tackled all the bags on their busses. This is a HOW TO: on the rears.
The following are Jon's comments on the procedure.
When going under the bus or between pinch points I do not rely on a single jack. I always have two means of support. Roger used a stack of wood blocks in addition to the jack, and I used two jacks per body lift point.
The Right Tool...
The wrench is what we used to make the few degrees of turn to loosen or tighten the front compression nuts. We used a die grinder with a 3" X 1/16 cutoff wheel to make the cut in the wrench. A hacksaw will not do it.
